Banner
Home > News > Content

What Are The Requirements For The Use Of Powder Automatic Packaging Machine

Dec 26, 2020

1. Electricity guarantee

The powder automatic packaging machine usually uses 380V three-phase power, and there are also custom applications with 220V two-phase power. Therefore, it is necessary to clearly connect the power supply corresponding to the equipment before application to ensure the stability of the power supply, otherwise it is very easy to cause the circuit The destruction.

2. Environmental requirements

The operation of the powder automatic packaging machine will also have certain requirements relative to the environment, mainly the humidity of the indoor air, the proportion of smoke and dust, etc. If the air humidity is too high, the electronic components will be destroyed, and the high proportion of smoke and dust may interfere with the heat dissipation of the equipment. If it belongs to flammable and explosive smoke, it is very easy to cause dust explosion if there is no protection during the start-up process.

3. Equipment lubrication

Equipment maintenance personnel should fill the gear meshes of the automatic powder packaging machine, the oil hole of the bearing with a seat, and the moving parts with oil on time. The reducer is not allowed to run without oil. When filling lubricating oil, be careful not to put the oil tank on the running belt to prevent slipping and loss of rotation or premature aging of the belt and damage.

Four, routine inspection

Before applying the powder automatic packaging machine, check the screws of each part. There must be no looseness, otherwise it will interfere with the normal long-distance rotation of the whole machine. Pay attention to waterproof, moisture-proof, anti-corrosion, and anti-rat , In order to ensure the nailing in the electric control box and the connection terminals to prevent common electrical faults. After the shutdown, the two heat sealers should be in the open position to prevent the packaging materials from being burned.

Five, clean on time

Under normal circumstances, after the shutdown, the metering parts should be cleaned in a timely manner, and the heat sealer body should be cleaned from time to time to ensure that the sealing lines of the packaged products are clear. Compared with the scattered materials, it should be cleaned and nailed to facilitate the mechanical parts. Nail it to better extend its service life. At the same time, it is necessary to clean the smoke and dust in the electric control box from time to time to prevent common electrical faults such as short circuit or poor contact.

6. Seasonal maintenance

In the process of applying the automatic powder packaging machine, the inspection and repair of components such as the fuel oil system, hydraulic system, cooling system and starting system should be emphasized every year before summer and winter.

Seven, stop maintenance

The automatic powder packaging machine needs to be out of service for a while due to seasonal factors (such as winter holidays) or production adjustments. It is necessary to do a good job of cleaning, plastic surgery, supporting, and anti-corrosion.


Back