Banner
Home > Knowledge > Content

Causes and solutions for shaft pressure slippage of biomass pellet machine

Jan 09, 2021

1. The bearing installation of the biomass pellet machine is not very flexible, which will cause the shaft to slip.

When installing the bearings of the biomass pellet machine drum, please do not install too hard, otherwise it will cause the biomass pellet machine to slip during the pelletizing process. A good way to deal with this situation is to always pay attention to the axial pressure of the roller, and replace it with a new roller immediately.

2. Too much moisture content in the pellets will affect the phenomenon of axial pressure and slippage

When the biomass pellet machine squeezes the raw material, the moisture content in the raw material is too much, or the steam caused by the biomass pellet machine is too large, and the axial pressure of the biomass pellet machine is caused by the lubrication of the moisture content during the production process . A good way to deal with this situation is to reduce the amount of steam in the raw materials and keep the water content in the raw materials within a reasonable range.

3. The axial pressure gap of the biomass pellet machine is too large to affect the phenomenon of axial pressure slippage

When the biomass pellet machine is used for use, if the gap between the axial pressure of the biomass pellet machine is not effectively adjusted, the pellets produced in the pelletizing process are not very uniform, the production volume is small, and it cannot be tight. Press biomass pellet machine. The pressed material is easily slipped by the shaft. A good solution can reduce the distance between the two spindles of the biomass pellet machine.

4. Excessive application of the axial pressure of the biomass pellet machine will affect the slippage of the axial pressure

Long-term application of particles may cause axial pressure wear (a basic component failure), which will cause the phenomenon of shaft pressure slippage, and will not operate normally. A good way to deal with the phenomenon of the axis pressure of the pellet machine is not only to keep the pellet machine clean from time to time, but also to replace the new axis pressure at any time.


Back